USG6000 series BGP modified equivalent number of routes

38

The method for configuring the maximum equivalent route entry for the USG6000 series BGP is as follows.

Run the system-view command to enter the system view.
Run the bgp as-number command to enter BGP view.
Run the ipv4-family unicast command to enter the IPv4 unicast address family view.
Run the maximum load-balancing number command to configure the number of BGP load balancing routes.

By default, the number of BGP load balancing routes is 1.
The maximum number of BGP routes is 8

Other related questions:
Modifying the number of equal-cost OSPF routes on the USG6000 series
Perform as follows to configure the maximum number of equal-cost OSPF routes on the USG6000 series: 1. In the user view, run the system-view command to enter the system view. 2. Run the ospf [ process-id ] command to access the OSPF process view. 3. Run the maximum load-balancing number command to configure the maximum number of equal-cost routes. A maximum of eight equal-cost OSPF routes are supported.

Reasons for the fact that the number of default equivalent routes in the routing table is larger than the number of default static routes
The reasons for the fact that the number of default equivalent routes in the routing table is larger than the number of default static routes are as follows: Symptom: Two default equivalent routes are configured. [sysname] display current-configuration | in ip route ip route-static 0.0.0.0 0.0.0.0 GigabitEthernet1/0/11 42.x.y.1 ip route-static 0.0.0.0 0.0.0.0 GigabitEthernet1/0/10 110.x.y.1 ip route-static 10.0.0.0 255.0.0.0 Eth-Trunk0 10.x.y.249 ...... The routing table has three default equivalent routes. Check whether the following interface is configured with the gateway function: [sysname] display current-configuration interface ...... # interface GigabitEthernet1/0/0 alias Cernet ip address 210.43.47.174 255.255.255.252 service-manage http permit service-manage https permit service-manage ping permit service-manage ssh permit service-manage snmp permit service-manage telnet permit gateway 210.x.y.173 # ...... The gateway command is used to configure the gateway address of the smart routing member interface. By default, the gateway address of the smart routing member interface is invalid. If the interface is used as the smart routing member interface, you must configure the gateway address for it. The firewall delivers the routing entry but does not automatically generate the route configuration command (ip route-static).

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top