Commands for querying routing table information on the firewall

42

Run the following commands to display routing table information on the firewall:
-Display the abstract information about the active routes in the routing table.
display ip routing-table
-Display the detailed information about the routing table.
display ip routing-table verbose
-Display the detailed information about the routing table.
display ip routing-table verbose
-Display the route to the specified destination IP address.
display ip routing-table ip-address [ mask | mask-length ] [ longer-match ] [ verbose ]

Other related questions:
How to check the routing table on an S series switch
Run the display ip routing-table command on the switch to check the IPv4 routing table. For example: [HUAWEI]display ip routing-table Perform the following steps to check the routing table through the web system on a switch that supports web-based management: 1. Choose IP Routing > IPv4 Route in the navigation tree to access the IPv4 Route page. Click the IPv4 Routing Tables tab. 2. Set the search criteria. 3. Click Query to view all the matching records. Note: You can query the routing table on the web system of the Classics edition, but cannot query the table on the web system of the EasyOperation edition.

Session table query on a firewall
You can query the session table on the web UI and CLI. For the USG6000 series, on the web UI, choose Monitor > Session Table to query the session table and NAT detailed information. For the USG2000&5000 series, on the web UI, choose Firewall > Monitor > Session Table to query the session table. For the USG2000&5000 and USG6000 series, you can run the display firewall session table command to view the session table, or run the display firewall session table nat command to view the NAT session table.

Query of session information of a specific protocol
For the USG2000&5000 and USG6000 series, you can run the display firewall session table [ verbose ] protocol protocol-name command to view session information about a specific protocol. The protocol can be TCP, UDP, or ICMP.

How to clear and query the firewall and NAT traffic table
Run the reset session all command in the system view to clear the firewall and NAT traffic table information. Run the display session command in any view to query the firewall and NAT traffic table information.

Viewing the routing table through the web UI of the firewall
Perform as follows to view the routing table through the web UI of the firewall: 1. Choose Network > Route > Routing Table. 2. Set search conditions.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top