Configuring automatic backup on the firewall

3

Run the hrp auto-sync [ config [ static-route ] | connection-status ] command in the system view.
By default, the automatic backup function of the firewall is enabled, but the automatic backup function of static routes is disabled.
You can run the hrp auto-sync config command to enable the automatic backup function (except for automatic backup of static routes). To enable automatic backup of static routes, run the hrp auto-sync config static-route command.
Only IPv4, not IPv6, static routes can be automatically backed up.

Other related questions:
What are the differences between automatic session backup and quick session backup
The differences between quick session backup and automatic session backup are as follows: -In quick session backup, sessions are synchronized to the standby firewall immediately after being set up. In automatic session backup, only sessions that require backup and are detected by the session aging thread are synchronized to the standby firewall. -The quick session backup function can back up half-open TCP sessions and sessions to the firewall. If the forward and return paths are different, enable quick session backup to ensure that the sessions on the two firewalls are the same.

Configuring automatic triggering of IPSec VPN on the firewall
Configuring automatic IPSec triggering (automatic negotiation) on the USG The auto-neg option can be configured in the case of establishing an IPSec tunnel in non-template mode, which indicates that an IPSec tunnel is established through auto-negotiation. If this option is not selected, traffic triggers the establishment of an IPSec tunnel. In the case of tunnel establishment in template mode, the configuration template end cannot proactively initiate the negotiation. In this case, if the non-template end does not send traffic, the tunnel fails to be established. At this moment, you can configure the auto-neg command on the non-template end to enable the IPSec auto-negotiation function. After auto-neg is configured at the non-template end, the system immediately checks data flows one by one. The non-template end proactively sends a negotiation request to the template end when no traffic is transmitted, and establishes an IPSec tunnel. The check is performed at a certain interval (far smaller than the SA lifetime) to ensure that all tunnels in the system are in the status of established. Configuration example Apply an IPSec policy group named policy1 to GigabitEthernet 0/0/3 and proactively initiate a tunnel connection. system-view [sysname] interface GigabitEthernet 0/0/3 [sysname-GigabitEthernet0/0/3] ipsec policy policy1 auto-neg

How to disable the automatic backup function on the U1980?
1. To disable the automatic backup function, log in to the U1900 gateway and run the config data autoupload disable uploadtime 21:00:00 command. 2. To enable the automatic backup function, run the config data autoupload enable uploadtime 11:00:00 command. Ensure that the value of hostip is the IP address of the FTPS server. 3. Backup method: TFTP/FTPS To view the backup method, run the show softargu configinfor id 478 command. To determine the backup mode, modify the value of the software parameter 478 by running the config softargu type 478 value X command. The options are as follows: 0: tftp 1: com 2: ftps (default)

Do S series switches support automatic backup of the configuration file to a server
S series switches (except S1700 switches) support automatic backup of the configuration file to a server. For more information, see: [Configuring an S series switch to save the configuration file to a server periodically]Configuring an S series switch to save the configuration file to a server periodically [Configuring S series switches to perform automatic configuration backup]Configuring S series switches to perform automatic configuration backup

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top