Configuring virtual IP addresses of VRRP groups on the USG6000

27

Configuring virtual IP addresses of VRRP groups on the USG6000
sys //Access the system view.
[USG6600-1] int g1/0/9 //Access the Layer 3 interface.
[USG6600-1-GigabitEthernet1/0/9]ip add 1.1.1.1 24 //Configure the interface IP address.
[USG6600-1-GigabitEthernet1/0/9]vrrp vrid 1 virtual-ip 1.1.1.254 active (virtual IP address of the VRRP group)
//Configure the virtual IP address of the VRRP group.

Other related questions:
Configuring virtual IP addresses of VRRP groups on the USG6000
Configuring virtual IP addresses of VRRP groups on the USG6000 sys //Access the system view. [USG6600-1] int g1/0/9 //Access the Layer 3 interface. [USG6600-1-GigabitEthernet1/0/9]ip add 1.1.1.1 24 //Configure the interface IP address. [USG6600-1-GigabitEthernet1/0/9]vrrp vrid 1 virtual-ip 1.1.1.254 active (virtual IP address of the VRRP group) //Configure the virtual IP address of the VRRP group.

Configuring OSPF to advertise virtual IP addresses of VRRP groups on the USG
In the OSPF zone, run the network command to advertise virtual addresses.

Whether SSL VPN of the USG6000 can use the virtual IP address of a VRRP group as the gateway
SSL VPN supports using the virtual IP address of the VRRP group as the gateway.

Why cannot the virtual IP address of a VRRP group be pinged
Check whether the vrrp virtual-ip ping disable or undo vrrp virtual-ip ping enable command is configured on an S series switch. If so, run the vrrp virtual-ip ping enable command to allow the master device to respond to ping packets sent to the virtual IP address.

Why does the ping to the virtual IP address of the VRRP group fail
Possible causes are as follows: -VRIDs conflict. -Pinging virtual IP addresses is disabled. Huawei firewalls enable you to ping virtual IP addresses by default. If ping virtual IP address is disabled, run the vrrp virtual-ip ping enable command.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top