Can I modify the call forwarding offline announcement on U1980

System software parameter 270 is used to control whether to play the call forwarding announcement on the U1900 series unified gateway. To disable the call forwarding announcement, perform the following steps: 1. Check the value of software parameter 270. (Value 0 indicates that the call forwarding announcement is disabled, and value 1 indicates that the call forwarding announcement is enabled.) If Current Value is empty, the default value 1 is used. [%eSpace U1981(config)]#show softargu configinfor id 270 ID : 270 Type : service Current Value: -- Desc : Whether to hear the prompt tone about the transfer reason [range: 0(NO), 1(YES)][default:1] 2. Change the value of software parameter 270 as required. config softargu type 270 value 0 //Call forwarding announcement is disabled. the value is-0 , when perform the forward service will be not any prompt config softargu type 270 value 1 //Call forwarding announcement is enabled. the value is 1 , when perform the forward service will be get tone to prompt- the call is redirecting- 3. Save the modification.

The U1900 series cannot record ongoing calls. You can purchase the eSpace Audio Recorder or third-party products to record ongoing calls. For more details, consult pre-sales engineers.

Yes. 1. Decompress the voice.zip file (obtained from the version software package) of the U1900. 2. Replace the tone in voice channel 238 with the tone to be loaded. The tone file name must be the same as the name of the original file. 3. Start the LMT. Choose Version > Voice File. 4. Click Browse, select a folder for storing audio files, and click OK. 5. Click Generate Voice File, select voice or mrsvoice on the displayed page, and click OK. 6. The loading is completed.

This problem occurs because the outgoing call permission of the incoming trunk is not enabled. For incoming calls through a trunk, configure the outgoing call permission of the trunk and configure number change for the calling numbers by running the following command: config modify trunkgroup no <0-6120> [restrict ] [outgoingright ] [clipredeal ] [cliindex <0-1023>] [domainType ] [callsourceno <0-255>] [trunklevel ]

Run the config softargutype 270 value 0 command to set software parameter 270 of the U1900 to 0.