Does the U1980 C20SPH604 patch incorporate issues resolved in SPH602

The method used to resolve the full log space issue on the USG6000 is as follows: 1. Choose System > Log Configuration. 2. Select the method used to process the logs when the disk space is full in Processing Mode. a. Overwrite: When the log storage space of the hard disk is insufficient, the hard disk receives new logs and discards the earliest logs. b. Discard: When the log storage space of the hard disk is insufficient, the device directly discards new logs and does not receive any logs. By default, when the log storage space of the hard disk is insufficient, the hard disk adopts the overwrite processing mode.

The address of the U1980 V100R001C01 patch release notes is .

To solve this problem, two methods are available: ?Using the CLI Run the config softargu type 350 value 1 command to set the value of the software parameter 350 to 1. The software parameter 350 specifies whether alarms are reported based on the Greenwich Mean Time (GMT) or local time. The options are as follows: 0: GMT 1: Local time ?Using the web UI Choose System Management > Time Configuration and modify the time zone. For example, modify the time zone to GMT + 08:00.

1. Run the show billserver state command to check whether the CDR server is correctly configured. If the configuration is incorrect, run the Config system billserver command to change the CDR server's IP address to the actual IP address. 2. Check whether the network connection is normal. If not, rectify the network fault. 3. Ensure that the CDR server is enabled. If this function is disabled, you need to enable the CDR server. 4. Check whether the accumulated CDR files under the Server Bill\CurFile directory of the CDR server are excessive. If yes, periodically archive these files or use the BMU to obtain CDR files, or set the CDR server to periodically delete CDR files. 5. Ensure that the transmission protocols on both ends are consistent, that is, both are TCP or TLS protocols.