Can an AR router as a called party disconnect an established dial-up link

39

Yes. You can run the dialer disconnect interface interface-type interface-number command to disconnect a dial-up link temporarily.

Other related questions:
Can an AR series router used as a called party tear down a dial-up link that has been set up
Yes. To temporarily tear down a dial-up link, run the dialer disconnect [ interface interface-type interface-number ] command.

Whether the AR router PPPoE dial-up lines bandwidth can be superimposed?
AR router PPPoE dial-up line bandwidth can not be superimposed, can not be achieved result like: 10M+10M=20M.

Can bandwidths of multiple PPPoE dialup line be summed up on the AR router
The bandwidth of multiple lines cannot overlap.

Can I bind multiple dial-up links to increase the bandwidth
Yes, you can bind multiple dial-up links to increase the bandwidth.

What are possible causes for L2TP dial-up failures of the AR router
Possible causes for L2TP dialup failures are as follows: - The firewall is configured on the public network or the local PC has the firewall, so L2TP packets are discarded. - When corresponding L2TP port is disabled or occupied, UDP port 1701 is often used. For example, ACL and NAT are configured. - The user name and password of the LAC are incorrect, or no users are specified for the LNS. - The configured address is incorrect. For example, the statically configured address of the VT interface is incorrect. - Tunnel authentication modes are different. - LCP renegotiation is not configured. - The IP address allocation is improper. The IP address pool has a small address range or not configured. - Gateway addresses are not configured in the IP address pool, so gateway addresses are allocated to clients. - There are unreachable routes. - In the L2TP group view, the specified tunnel name at the remote end is incorrect. - The configured authentication domain is incorrect. - L2TP negotiation fails because control packets sent by clients of the local PC do not carry the SQ. - When IPSec encryption is used, the IPSec parameters on the two ends of the tunnel are inconsistent.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top