Can an outbound interface be specified for dial-up in the resource-shared DCC dial-up method

19

Yes. You can run the dialer route ip next-hop-address user hostname | broadcast * dial-string autodial | interface interface-type interface-number * command to specify an outbound interface for dial-up.

Other related questions:
Which command can be run to set the DCC automatic dial-up interval
You can run the dialer timer autodial seconds command to set the interval of DCC automatic dial-up. In the command, seconds indicates the interval between the latest call to the next call attempt, which is an integer ranged from 1 to 604,800 and is measured by seconds. The interval of DCC automatic dial-up is 300 seconds by default. Note: Before run the command, run the dialer enable-circular command to enable the circular DCC.

Automatic LAC dial-up
In automatic LAC dial-up scenarios, the LAC does not authenticate users. All users configured on the LAC are authenticated by the LNS through PPP authentication (PAP or CHAP). In CLI configurations, this is the PPP authentication configured on the VT interface.

Whether the dial-up interface supports hot standby
No. Hot standby interfaces require fixed IP addresses.

Can I specify an outbound interface for the circular DCC
Yes. To specify an outbound interface, run the dialer route ip next-hop-address [ user hostname | broadcast ] * [ dial-string [ autodial | interface interface-type interface-number ] * ] command.

Can the circular DCC method and the resource-shared DCC method interwork with each other
The circular DCC method and the resource-shared DCC method can interwork with each other.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top