Does the U1910 configured with the SS7 signaling support the transmission of voice data and signaling data through different channels?

The configuration example and related interconnection parameters are list as follows: Network ID: national network Length of the signaling point code: 24-bit Signaling point: U1900:010101 Voice channel timeslot: 020202 STP (signaling timeslot): 111111 SLC:0 CIC value range: 0?31 Signaling timeslot: 16 conf add interoffice index 0 npc1 010101 conf add dsp index 0 name Eq interofficeindex 0 npc1 020202 adjacencyflag no conf add dsp index 1 name STP interofficeindex 0 npc1 111111 stpflag yes conf add mtplinkset index 0 dpx 1 conf add mtproute linksetindex 0 dpx 0 conf add mtproute linksetindex 0 dpx 1 ******config add office selectcode no 0 repeatroute no selecttype none******* conf add office no 0 officeselectcode 0 dpx 0 conf add office no 1 officeselectcode 0 dpx 1 //Add the voice channel conf add board slot 3 type dtu officeno 0 signallingtype isup startcic 0 //Add the timeslot 16 for transmitting signaling streams config modify board slot 3 type dtu tkcinboard 16-16 officeno 1 conf add mtplink linkindex 0 slot 3 trunkport 0 linksetindex 0 slc 0 ts 16

When the U1900 unified gateway is connected to the peer device through the SS7 trunk, voice data and signaling data can be sent through the same or different channels. For details about how to configure the trunk in the two scenarios, see Configuration > Configuration Guide > Configuring Trunks > Configuring Signaling Data in the eSpace U1900 Series Unified Gateway Product Documentation. Note: Of all the U1900 models, the U1910 does not support transmission of voice data and signaling data through different channels.. It is not recommended to send the voice data and signaling data through different channels when only one trunk cable is used.

The SPC is provided by the carrier in hexadecimal notation.

The U1900 series unified gateway supports separation of voice streams from data streams for SS7 signaling. For details about the SS7 signaling configuration, see the U1900 product documentation of the corresponding version.