Method used to set up an IPSec tunnel between two ARs that both use PPPoE dialup

22

Huawei AR routers support an IPSec tunnel between two ARs that both use PPPoE dialup. For details about the configuration, see "5.4.6 Example for Configuring an IPSec Tunnel for Remote Dial-Up Users to Connect to the Headquarters" of "Using VPN to Implement WAN Interconnection" in Typical Configuration Examples.

Other related questions:
Method used to configure IPSec on the 3G interface of the AR
Huawei AR series routers can dynamically obtain IP addresses from a service provider to access public network using a 3G interface, and establish IPSec connections with the headquarters. This function applies to V200R002C00 and later versions and all models of the AR. For details, see Typical Configuration Examples.

Method used to configure IPSec through an interface with a dynamic IP address on the AR
Huawei AR routers support IPSec networking where one side has a dynamic IP address and the other side has a fixed IP address. There is no difference on the configuration method between different versions and models. For details about the configuration, see "Does the Interface with a Dynamic IP Address Support IPSec?" of "IPSec Configuration" in Configuration Guide - VPN.

Method used to establish an IPSec tunnel between the AR and PC
An IPSec tunnel is established between the AR and PC. This example applies to all AR models of V200R002C00 and later versions. For details about the configuration, see "Example for Configuring an IPSec Tunnel for Remote Dial-Up Users to Connect to the Headquarters" of "Using VPN to Implement WAN Interconnection" in Typical Configuration Examples.

Method used to configure an IPSec tunnel on the AR for mutual access between branches
There are two ways of implementing communication between branches on Huawei AR routers. 1. Branches directly communicate with each other. In this case, implementing communication between branches through configuration of IPSec and DSVPN (not supported by the AR510). For details, see "Example for configuring IPSec-based DSVPN" of "DSVPN Configuration" in Configuration Guide - VPN. 2. Branches communicate with each other through the headquarters. For details, see "Example for Configuring GRE Over IPSec to Implement Communication Between the Branches and Headquarters and NAT to Implement Communication Between Branches (Running OSPF)" of "Using VPN to Implement WAN Interconnection" in Typical Configuration Examples.

Method used to configure an IPSec tunnel for interconnection between an AR and a Cisco device
Huawei AR routers can connect to Cisco devices through IPSec tunnels. This example applies to all AR models of V200R005C10 and later versions. For details about the configuration process, see "Example for Configuring the Headquarters to Manage Branches (Cisco Routers) Using Efficient VPN and Establishing IPSec Tunnels" and "Example for Configuring the Headquarters (Cisco Router) to Manage Branches Using Efficient VPN and Establishing IPSec Tunnels" of "Using VPN to Implement WAN Interconnection" in Typical Configuration Examples.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top