All configured firewall functions take effect after the firewall functions are enabled in interzones.
If an interzone contains the Local zone, to enable the firewall functions to take effect in this interzone, run the ip soft-forward enhance enable command in the system view to enable the IP address enhanced forwarding function of the router.
Run the system-view command to access the system view.
Run the firewall interzone zone-name1 zone-name2 command to access the interzone view.
The zone-name1 and zone-name2 have been created by running the firewall zone command.
Run the firewall enable command to enable the firewall functions.
By default, the firewall functions of the interzone are not enabled.
Run the undo firewall enable command to disable the firewall functions of the interzone.
Run the display firewall interzone [ zone-name1 zone-name2 ] command to query information about the interzone.
Disable the NTP service on the firewall as follows:
1. Run the system-view command to enter the system view.
2. Run the following commands to disable the NTP service.
a. Run the ntp-service [ ipv6 ] disable command to disable the NTP service.
By default, the NTP function is enabled.
b. Run the ntp-service [ ipv6 ] server disable command to disable the function that the FW serves as the NTP server.
By default, the NTP server function is enabled.
The firewall used for security hardening cannot be disabled, but its ports can be restricted.
The firewall that is not used for security hardening can be disabled.
To disable autofocus of VPC620 or VPC600:
Configure IR to LOCAL for VPC620, press the back key on the remote control twice to open the menu, and set AF MODE to MANUAL.
If you have more questions, you can seek help from following ways:
