Connection of the CXP high-speed cable

23

Connection of the CXP high-speed cable on the MA5616: One end of the cable is connected to the VEI port of the cascading MA5616,
and the other end is connected to that of the cascaded MA5616.

Other related questions:
High-speed networks
A high-speed network is an internal network among BMSs and provides unlimited bandwidth for connecting BMSs in the same AZ. If you want to deploy services requiring high throughput and low latency, you can create high-speed networks. Currently, the BMS supports high-speed networks with a maximum bandwidth of 10 Gbit/s.

Stack cables supported by S series fixed switches
For details about stack cables supported by S series fixed switches, click Typical Configuration Examples and choose Typical Stack Configuration of Fixed Switches- Determining the Stack Connection Mode and Hardware and Software Requirements. This section describes whether each model and version of S series fixed switches supports stacking as well as stack modes, hardware and software requirements, typical networking, configuration steps, and also stack cables used to set up various stacks.

Whether the USG2000 slots fall into high-speed and low-speed ones
No.

Clearing of the LSR_WILL_DIE alarm after the fan speed is adjusted to high speed
The LSR_WILL_DIE alarm is a module alarm and is affected by the temperature. It is reported when the module is in the high temperature environment and ages quickly. You are advised to replace the module or board even if the LSR _ WILL _ DIE alarm is cleared by increasing the fan speed.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top