How can I re-install the VCN500 after its hard disk is replaced?

For the USG6000 (1 U device), perform as follows to install the hard disk combination SM-HDD-SAS300G-B for the first time: 1. Loosen screws on the filler panel and remove the filler panel. 2. Hold the two side surfaces of a hard disk unit, push the hard disk combination into the slot along the guide rails until it is well seated into the slot, and fasten screws on the two sides of the hard disk unit. 3. After that, run the display disk information command in the user view. If Filesystem Status is Mounted in the command output, the hard disk is successfully installed. For the USG6000 (3 U device), perform as follows to install the hard disk unit SM-HDD-SAS300G-A for the first time: 1. Remove the filler panel from a hard disk slot. 2. Hold the handlers of the tray and push the tray along the guide rails inside the hard disk slot till the tray panel aligns with the panel of the device. 3. Press the tray handler inwardly to restore the tray. 4. If there are two hard disks, repeat steps 1 to 3 to install the other hard disk. 5. After the installation completes, check as follows: -If a single hard disk exists, run the display disk information command in the user view. If Filesystem Status is Mounted in the command output, the hard disk is successfully installed. -If two hard disks exist, run the display disk information command in the user view to check whether the Filesystem Status value is Un-Mounted and the DiskRaidMode value is INACTIVE. Then, in the system view, run the reset raid primary-disk disk-id command to create a RAID group using disk-id as the primary disk for data synchronization. The synchronization process will take several hours. During data synchronization, other services can be used, but the hard disks do not record real-time logs for the services. After data synchronization completes, the hard disks automatically start to work. You can run the display disk information command in the user view on the next day to check whether Filesystem Status is Mounted. If no, contact Huawei technical support personnel. When a hard disk is faulty, replace it. For details, see content relevant to replacing hard disks on the USG6000 series in the product documentation.

The USG6000 hard disk supports formatting. However, formatting a hard disk may cause disk data to be lost. Exercise caution when you perform this operation. To format a hard disk, run the reset disk command in the diagnose view. system-view [sysname] diagnose [sysname-diagnose] reset disk

Disks are inserted into the VCN3000 and VCN500 before being delivered.