How can I configure Boolean value alarm linkage when the IPC6225-VRZ connects to the VCN3000?

When OSPF imports external routes, the cost of original routes is not used. By default, the cost of the external routes imported by OSPF is 1. To change the default cost value of external routes imported by OSPF, run the default { cost { cost | inherit-metric } command. In the preceding command: -cost: specifies the cost of the imported external routes. The value is an integer ranging from 0 to 16777214. -inherit-metric: indicates that the cost of the imported external routes is the cost carried in the route.

Basic Concept If a specified port of a CE switch is connected to no other switching devices but directly connected to a server, the port can be configured as an edge port. The edge port will not participate in spanning tree calculation, which speeds up network topology convergence and enhances network stability. In normal cases, an edge port does not receive any BPDUs. If a switch is attacked by forged BPDUs, edge ports will receive BPDUs. The switch then sets the edge ports as non-edge ports and recalculates the spanning tree, resulting in network flapping. You can configure BPDU protection to defend against network attacks of this type. Configuration When a CE switch connects to a server, configure the port connected to the server as an edge port and configure BPDU protection. The following takes the RSTP mode as an example: system-view [~HUAWEI] stp mode rstp //Set the STP working mode to RSTP. [*HUAWEI] interface 10ge 1/0/1 [*HUAWEI-10GE1/0/1] stp edged-port enable //Configure the port as an edge port. [*HUAWEI-10GE1/0/1] quit [*HUAWEI] stp bpdu-protection //Enable BPDU protection. [*HUAWEI] commit

The default MTU value of the conference endpoint is 1500. You can choose System Settings > Network > Common Settings on the web page of the TE to change the value.

The three models of cameras can connect to the eSpace IVS V100R001C02 platform through the HWSDK or ONVIF protocol.

IPC6231-WD-VRZ can report the following types of alarms to the VCN3000 platform: motion detection, lens block, and Boolean value output. IPC6231-WD-VRZ can report only Boolean value output alarms to eSight.