How can I query the service address of the VCN3000?

The IPTV mode needs to be enabled only when the host service is IPTV. The command for enabling the IPTV mode can be executed only on the primary controller. The IPTV service refers to the video on demand (VOD) and recording services. The database is not the IPTV service. 1. Query the service mode. Log in to the CLI and run showservicemode to query the service mode. 2. Set the IPTV mode. Log in to the CLI and run setservicemode -m 1 to enable the IPTV mode. Note: The IPTV mode needs only to be enabled on one controller. After the IPTV mode is enabled, run resetsys to restart the system for the IPTV mode to take effect. 3. Restart the system as follows: OceanStor: admin > resetsys

Method used to query and modify IP addresses: 1. Check storage management IP addresses. On the OSM page, choose System > Controller Information. Log in to the storage's debug mode and enter ifconfig eth0 to check IP addresses. Note: If the storage management IP address has not been changed, by default, the IP addresses are as follows: Controller A: 192.168.128.101 Controller B: 192.168.128.102 2. Modify the storage management IP addresses (on the master controller). Log in to the CLI mode and enter chgctrlip -c controller ID [-a IP] [-s mask] [-s gateway]. OceanStor: admin> chgctrlip -c A -a 129.16.46.55 3. Check storage alarm trap IP addresses. On the OSM page, choose Alarm > Configuration Operation > Configuration Operation > Trap IP. In the CLI mode, log in to the storage's CLI mode and enter showtrapip. 4. Check the storage's local heartbeat IP addresses. Log in to the storage's debug mode and enter ifconfig bond0.

In the V100R003C10 and later versions, query node IP addresses in SC node information on the SMC2.0.

The IP address of the IP phone cannot be queried on the U1900. You can run the show subscriber dn xxxx command to query the EID corresponding to the user number. Then run the show sipue eid xxxx command to query the registered IP address of the number.

You can run the following command to query the special services configured for a SIP user: show subscriber dn 6003 type newservice