How can I configure the VCM5010 service board IP address?

The TOM board does not support port bandwidth limit. All OTN boards do not support this function. The function is supported only by the service boards that support the L2 processing capability, such as TEM28 and LEM24.

There are three methods of configuring services on the LOA board: 1. By site manually 2. Using service packages for the LOA board 3. By trail

The procedure for configuring services on the TN52TOM board is as follows: 1. Configure the working mode of the TN52TOM board and the working mode of its ports. 2. Set the service type of its LP port. 3. Create a service from a physical port to an LP port. 4. Create a service from its LP port to a line board.

Method used to configure service IP addresses for an OceanStor V3 storage system: In the rear view of the device displayed in OceanStor DeviceManager, click the port whose IP address you want to modify and modify the IP address.

The backup policy for the main control board and service board of the MCU is as follows: The main control board and service board of the MCU both work in 1+1 hot standby mode. When the active board is faulty, the system will automatically switch to the standby board. The active/standby switchover time of the control board GCC is about 10s, which does not affect services. After the active/standby switchover of the service board GPU, the MCU service address will be changed and its services are interrupted for 15s to 30s. Notes: Not all MCU models support the main control board and service board backup. 1. The ViewPoint 9660 MCU supports main control board and service board backup; the ViewPoint 9650 MCU supports service board backup; the ViewPoint 9630 MCU does not support main control board or service board backup. 2. The ViewPoint 8660 MCU supports main control board and service board backup; the ViewPoint 8650 MCU supports only service board backup; the ViewPoint 8650C MCU does not support main control board or service board backup.