How many VOBA boards can be connected to a ViewPoint 8000 series MCU?

The PSTN board can be inserted into ViewPoint 8000 series MCUs.

Cables between E1/4E1 boards and their connection boxes of ViewPoint 8000 series MCUs are universal. E1 and 4E1 boards and connection boxes are different; however, cables between the boards and connection boxes are universal DB36 to DB68 cables.

ViewPoint 8000 series MCUs V100R007 and earlier versions do not provide web interfaces. You can configure the IP addresses for the MCUs in CLI mode. The network-config command is used to set network parameters for the GE1 ports and boards. To configure the GE1 port in slot 1 of a board, run the following commands: [MCU8660]network-config 1/2 ip version{0:ipv4 1:ipv6} [0]: ip address [192.168.1.201]: Mask [255.255.255.0]: default gateway [192.168.1.1]: 0: 10Mbps half duplex 1: 10Mbps full duplex 2: 100Mbps half duplex 3: 100Mbps full duplex 4: 1000Mbps full duplex 5: auto negotiation Notes: In the network-config A/B command, A specifies a slot, and B specifies a port whose value ranges from 0 to 2. Value 0 indicates an FE port, 1 indicates a GE0 port, and 2 indicates a GE1 port. ViewPoint 8000 series MCU V100R008 and later versions provide web interfaces. You can log in to the web interface of an MCU and choose Settings > Network to configure the IP addresses.

The Huawei ViewPoint 8000 series endpoint cannot be connected to IPCs. IPCs are digital video cameras. The digital video signals are transmitted through network cables. The Huawei 8000 series endpoint can only receive analog signals through video ports.

Both the ViewPoint 9000 series endpoint and the ViewPoint 8000 series endpoint have E1 and 4E1 boards. The same type of boards can be shared between them.