Whether the Huawei ViewPoint 8000 series endpoint can display video through the SXGA port

For details about specifications of the ViewPoint 8000 series endpoint, visit the ViewPoint 8000 series endpoint.

You cannot set image inversion on the Huawei ViewPoint 8000 series endpoint. You need to adjust the image on the camera. For example, turn the Flip switch to ON on the back of the SONY D70 camera, the displayed image is inverted.

Perform troubleshooting based on the following possible causes: 1. The mode of the endpoint output port is not set correctly. The mode of the endpoint output port should be the same as the mode of the display input port. For example, when you configure the endpoint settings, select Video output on the remote control UI, and set the output mode to S-Video in Setting if the display supports S-Video, or set the output mode to CVBS in Setting if the display supports CVBS. 2. A transfer cable is used for video input. The Huawei ViewPoint 8000 series endpoint supports the S-Video or CVBS cable only for video input. The S-Video-to-CVBS cable is not supported, but it applies to video output. When the camera uses the CVBS port, connect the endpoint through the Video IN 2 port, and set the input source to Video IN 2 on the remote control UI. When the camera uses the S-Video port, connect the endpoint through the Video IN 1 port, and set the input source to Video IN 1 on the remote control UI.

Perform the following operation to enable an 8000 series endpoint to transmit video and presentation streams through one port: Set the video output to OUT 1, and disable other output ports (including SXGA, OUT 2, and OUT 3 ports). Enable the PiP function when a presentation is delivered.

The VGA ports of the Huawei ViewPoint 8000 series endpoint cannot deliver video but the presentation only.