Got it

Introduction to specifications of the Huawei ViewPoint 8000 series endpoint

195

For details about specifications of the ViewPoint 8000 series endpoint, visit the ViewPoint 8000 series endpoint.

Other related questions:
How to enable the H.261 protocol on the Huawei ViewPoint 8000 series endpoint
You need to log in to the endpoint through Telnet and run commands to enable the H.261 protocol on the Huawei ViewPoint 8000 series endpoint. Step 1. To enable the H.261 protocol for transmitting video and audio streams or presentations: a. Run the following command to enable the H.261 cif capability for transmitting video and audio streams: mc videoCap add main h261 cif b. Run the following command to enable the H.261 Qcif capability for delivering presentations: mc videoCap add aux h261 Qcif NOTE: To initiate a single-stream conference, enable only the H.261 capability for transmitting video and audio streams. Step 2. To display the H.261 protocol option on or remove it from the remote control UI, run the following command: rc set h261 on//Display the option rc set h261 off//Remove the option
Whether the Huawei ViewPoint 8000 series endpoint supports image inversion
You cannot set image inversion on the Huawei ViewPoint 8000 series endpoint. You need to adjust the image on the camera. For example, turn the Flip switch to ON on the back of the SONY D70 camera, the displayed image is inverted.
What is the default IP address of the Huawei ViewPoint 8000 series endpoint
The default (factory setting) IP address of a Huawei ViewPoint 8000 series endpoint is 192.168.1.1 or 10.76.167.31.
DIP switch position on the Huawei ViewPoint 8000/9000 series endpoint
The DIP switch is located at the norm side of the Huawei ViewPoint 8000/9000 series endpoint.
The video displayed by the Huawei Viewpoint 8000 series endpoint is in black and white.
Perform troubleshooting based on the following possible causes: 1. The mode of the endpoint output port is not set correctly. The mode of the endpoint output port should be the same as the mode of the display input port. For example, when you configure the endpoint settings, select Video output on the remote control UI, and set the output mode to S-Video in Setting if the display supports S-Video, or set the output mode to CVBS in Setting if the display supports CVBS. 2. A transfer cable is used for video input. The Huawei ViewPoint 8000 series endpoint supports the S-Video or CVBS cable only for video input. The S-Video-to-CVBS cable is not supported, but it applies to video output. When the camera uses the CVBS port, connect the endpoint through the Video IN 2 port, and set the input source to Video IN 2 on the remote control UI. When the camera uses the S-Video port, connect the endpoint through the Video IN 1 port, and set the input source to Video IN 1 on the remote control UI.
If you have more questions, you can seek help from following ways:
To WeiKnow To Live Chat

Login and enjoy all the member benefits

Login

Block
Are you sure to block this user?
Users on your blacklist cannot comment on your post,cannot mention you, cannot send you private messages.
Reminder
Please bind your phone number to obtain invitation bonus.