How to enable the Huawei ViewPoint 9000 series endpoint to start automatically once they are powered on

To enable automatic answering on a ViewPoint 9000 series endpoint, perform the following operations: Log in to the web interface, choose Settings > Basic Parameters, enable automatic answering, and save the settings.

Turn the DIP switch 2 to Load on the back panel of the endpoint.

"Video capabilities of the Huawei ViewPoint 9000 series endpoint: ViewPoint 9039, ViewPoint 9036, ViewPoint 9035, and ViewPoint 9033: HD OUT 1: This video output port is used to transmit local video, remote video, and presentations. It supports the combined picture mode. If the endpoint is not in any conference, this port delivers the local video stream by default; after the endpoint joins a conference, this port delivers the remote video stream by default. HD OUT 2: This video output port is used to transmit local video, remote video, and presentations. It does not support the combined picture mode. If the endpoint is not in any conference, this port delivers the local video by default; after the endpoint joins a conference, this port delivers the remote video by default. HD OUT 3: This video output port is used to transmit local video, remote video, and presentations. It does not support the combined picture mode. If the endpoint is not in any conference, this port delivers the local video by default; after the endpoint joins a conference, this port delivers the remote video by default.

Password of the remote control of the Huawei ViewPoint 9000 series endpoint: The password of the remote control UI is empty or 12345678.

To enable the H.263+ protocol on the Huawei ViewPoint 9000 series endpoint, log in to the endpoint through Telnet and run the following command: mc set RFC2429 x y Parameter description: If parameter X is 0, the command takes effect on video. If parameter X is 1, the command takes effect on presentations. If parameter Y is 0, the protocol is disabled. If parameter Y is 1, the protocol is enabled. NOTE: For V100R011C02 and later versions, the H.263+ protocol is disabled for the video by default, but it is enabled for the presentation by default. For versions earlier than V100R011C02, the H.263+ protocol is disabled for the video and presentation by default.