How do I restore VP96XX series MCUs to factory defaults?

Procedure 1. Run the reset saved-configuration command to clear the configuration file for the next startup and delete the configuration file used in the next startup. 2. Run the reboot fast command to restart the system.

Restore factory settings of the S1700 using either of the following methods: 1. Hold down the Reset button. When you hold down the Reset button for more than 5s, the switch restarts and restores the factory settings. (If you forget the changed management IP address or password of a switch, you can hold down the Reset button to restore factory settings of the switch.) 2. Restore the factory settings through the web. a. Choose System Management > Reset Factory. b. Click Reset Factory. c. Click Apply.

To revoke the license of VP96XX series MCUs, perform the following operations: Log in to the MCU web interface, choose Settings > System status > License, and manually revoke the license.

To restore the MCU to factory defaults in CLI mode, perform the following operations: 1. Log in to the MCU as the administrator user in SSH2 mode. 2. Run the file rm-config command to delete the configuration file. 3. Run the reboot command to restart the MCU. After the MCU is restarted, all configurations are restored to factory defaults.

You can restore the IAD to factory settings in either of the following ways: Log in to the web management system, and choose System Tool > Maintenance > Restore Default. On the page that is displayed, select Factory setting, and click OK. Restart the IAD for the settings to take effect. Log in to the CLI, and run the enable and configure terminal commands in sequence to enter the global configuration mode. Then run the restore vendor-config command. Restart the IAD for the settings to take effect.