Can rate limiting based on a private network segment be configured on a public network interface

0

Rate limiting can be configured on a public network interface based on a private network segment.

Other related questions:
Configure rate limiting for a network segment on an AR
1. Configure an ACL to match the network segment on which the rate of packets needs to be limited. # acl number 2000 //Create ACL 2000. rule 0 permit source 192.168.1.0 0.0.0.255 //Configure rule 0 to allow packets with source IP address 192.168.1.0 to pass. # 2. Configure rate limiting for the data flow that matches a traffic classifier on the interface connecting to intranet users. # interface GigabitEthernet3/0/0 ip address 192.168.1.1 255.255.255.0 qos car inbound acl 2000 cir 512 cbs 32000 pbs 432000 green pass yellow pass red discard //Configure traffic monitoring for packets that match ACL 2000 on the inbound interface, and specify CIR to 512 kbit/s. #

Does an AR support rate limiting based on network segments
On AR routers in versions later than V200R002C00, you can run the qos car command to configure rate limiting based on network segments.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top