Time when the Trap IP address is configured

0

After the Trap IP address management is set, the alarms are sent to the specified application server or maintenance terminal. The ISM provides the function of setting the Trap IP address for the alarms. Through this function, the alarms about the storage devices managed by the ISM client can be reported to another network management system (NMS) or a device with the specific IP address. If the alarm is reported in SNMP mode, the trap IP address needs to be set.

Other related questions:
Precautions of configuring the Trap IP address
If Trap IP parameters are not properly configured, alarms may not be reported to the specified server. Note the following: To implement the trap IP function, you need to install relevant software on the application server. For example, on Windows 2003 operating systems, the MIB Browser 8 software is required. The IP address format is XXX.XXX.XXX.XXX. Each field must be an integer. From left to right, the value of the first field ranges from 1 to 223. Please note that 127.0.0.1 is a loopback address. To avoid conflicts with the loopback address, it is not recommended to set this field to 127. The value of the last field ranges from 1 to 254. The values of the other fields range from 0 to 255.

When the eSpace 7900 series or 8950 IP phone is connected to the PC in series, how to configure different VLANs for the phone and PC?
The IP phone and PC can be in different VLANs, but in the scenario where the Link Layer Discovery Protocol (LLDP) is used, the IP phone and PC cannot be allocated in different VLANs.

Can the mapping between IP addresses be configured when there is only one public IP address
The mapping between IP addresses can be configured only when there are multiple public IP addresses.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top