Precautions of configuring the Trap IP address

6

If Trap IP parameters are not properly configured, alarms may not be reported to the specified server.
Note the following:
To implement the trap IP function, you need to install relevant software on the application server. For example, on Windows 2003 operating systems, the MIB Browser 8 software is required.
The IP address format is XXX.XXX.XXX.XXX. Each field must be an integer.
From left to right, the value of the first field ranges from 1 to 223. Please note that 127.0.0.1 is a loopback address. To avoid conflicts with the loopback address, it is not recommended to set this field to 127.
The value of the last field ranges from 1 to 254.
The values of the other fields range from 0 to 255.

Other related questions:
Time when the Trap IP address is configured
After the Trap IP address management is set, the alarms are sent to the specified application server or maintenance terminal. The ISM provides the function of setting the Trap IP address for the alarms. Through this function, the alarms about the storage devices managed by the ISM client can be reported to another network management system (NMS) or a device with the specific IP address. If the alarm is reported in SNMP mode, the trap IP address needs to be set.

Precautions on changing the egress IP address on the USG6000
Change the interface IP address and next hop of the route.

Precautions for changing NE IDs and IP addresses on the U2000
Take the following precautions when changing an NE ID: 1. Changing an NE ID is risky because it will interrupt NE communication. 2. Before changing an NE ID, delete protection groups, fiber connections, and functions such as IPA and ALC from the NE. After changing the NE ID, restore them for the NE on the U2000. 3. Before changing an NE ID, delete the manually added monitoring relationship between the WMU board and the OTU or line board on the NE. After changing the NE ID, restore the deleted monitoring relationship on the U2000. 4. For a gateway NE, after changing its NE ID, you need to re-create fiber connections between it and other NEs and re-specify the primary gateway NE for NEs that were originally connected to this gateway NE on the U2000. 5. If the IP address of an NE is not changed before you change the NE ID, the IP address of the NE varies according to the NE ID. Once the IP address of the NE is changed, the association between the NE ID and IP address is canceled automatically. Take the following precautions when changing an NE IP address: 1. Changing an NE IP address will reset the NE. 2. After changing the IP address of a gateway NE, you need to re-specify the IP address of the gateway NE in the DCN management window on the U2000, and re-specify the primary gateway NE for NEs that were originally connected to this gateway NE.

What should be noted when using PoE power supplies
In the versions earlier than V100R005, all PoE power supplies are 250 W non-constant current power supplies. When two power supplies are used, they are used for power redundancy, but do not offer power. In V100R005 and later versions, PoE power supplies include 250 W and 500 W constant current power supplies. When two 250 W or 500 W constant current power supplies are used, the power supplies can be used for power redundancy and offer power at the same time. In V200R002 and later versions, PoE power supplies include 250 W, 500 W, 580 W, and 1150 W constant current power supplies. When two 580 W or 1150 W constant current power supplies are used, the power supplies can be used for power redundancy and offer power at the same time.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top