Method used to change the ID of an OceanStor V3 disk enclosure

2

The ID of an OceanStor V3 disk enclosure cannot be changed.

Other related questions:
V3 disk enclosure
V3 disk enclosures are described as follows: A disk enclosure adopts a modular design and consists of a system enclosure, expansion modules, power modules, and disk modules.

Cascading levels of disk enclosures in the OceanStor V3 series
Cascading levels of disk enclosures in OceanStor V3 V300R001: A SAS port supports a maximum of eight disk enclosures. However, it is a good practice to connect at most five disk enclosures to one SAS port and eight high-density disk enclosures to two SAS ports.

Heat dissipation methods of the OceanStor V3 Series high-density disk enclosures
A special design enables greater heat dissipation. The air volume of fans used for high-density disk enclosures is larger than that of fans used for common disk enclosures. In addition, the air duct system is optimized to dissipate heat.

Disk enclosure layout on OceanStor V3 storage systems
All enclosures are evenly distributed among the SAS ports. The quantity difference of disk enclosures connected to each SAS port cannot exceed one. For details about the networking, see the Huawei Storage Networking Assistant: http://support.huawei.com/onlinetoolsweb/sna/?language=en

Method used to connect the storage device's controller enclosures and disk enclosures
Visit the following website and refer to the networking assistant: http://support.huawei.com/onlinetoolsweb/sna/?language=en

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top