How do I configure NQA for a VPN instance

38

The VPN instancne cannot be configured for the NQA test instance of DNS or NQA.
For example, configure the VPN instance vrf1 for the NQA test instance user test.
[Huawei] nqa test-instance user test
[Huawei-nqa-user-test] test-type icmp
[Huawei-nqa-user-test] vpn-instance vrf1

Other related questions:
How do I configure association between VRRP and NQA test instances on an S series switch
To configure association between VRRP and NQA test instances on an S series switch (except the S1700), perform the following operations: 1. Run the system-view command to enter the system view. 2. Run the interface interface-type interface-number[.subinterface-number ] command to enter the view of the interface to which the VRRP group belongs. 3. Run the vrrp vrid virtual-router-id track nqa admin-name test-name [ reduced value-reduced ] command to configure VRRP to track an NQA test instance. By default, when the tracked NQA test instance becomes Down, the priority decreases by 10. reduced value-reduced: specifies the value by which the VRRP priority reduces if the tracked NQA test instance becomes Down. The value ranges from 1 to 255. The minimum value of the priority is 0. Priority value 0 is reserved for special use. If a backup device receives a VRRP IPv6 Advertisement packet carrying the priority value of 0, the backup device immediately preempts the Master state. Note: The NQA function is controlled by a license. The commands related to NQA can be used on a newly purchased device but does not take effect. To use the NQA function, apply for and purchase a license from a Huawei local office. VRRP can also associate with BFD or a routing protocol to implement an active/standby switchover. For detailed configuration procedure, see section "Common VRRP Operations" at S1720&S2700&S3700&S5700&S6700&S7700&S9700 Common Operation Guide. The configuration method for the S9300 is the same as that for other switch models.

VPN instance configuration on S series switch
For the configuration of BGP/MPLS IP VPN: On the S12700, see Example for Configuring BGP/MPLS IP VPN in the S12700 Typical Configuration Examples. On the S1720&S2700&S3700&S5700&S6700&S7700&S9700, see Example for Configuring BGP/MPLS IP VPN in the S1720&S2700&S3700&S5700&S6700&S7700&S9700 Typical Configuration Examples. On the S9300, see Example for Configuring BGP/MPLS IP VPN in the Sx300 Series Switches Typical Configuration Examples.

How can I view the result of an NQA test instance
Run the display nqa results [ collection | success | failed ] test-instance admin-name test-name command to view the result of an NQA test instance.

Run the display nqa history test-instance admin-name test-name [ from start-date start-time to end-date end-time ] command to view the result of a history NQA test instance.


If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top