Actions taken if the start physical IP address cannot be connected

1

If a PC fails to connect to the start physical IP address of a file engine's management network port, perform the following procedure:
1. Ensure that management network cables are correctly connected.
2. Ensure that other IP addresses of the file engine are on the same network segment with its start physical IP address. For example, the configured start physical IP address of a file engine is 192.168.1.1/255.255.0.0. The file engine's access network ports must have an IP address from the 192.168.X.X network segment.
3. Run the ping command.

Other related questions:
Actions taken if an IP address fails to be configured
If an IP address fails to be configured, perform the following procedure: 1. Modify the configurations based on the error message. 2. Ensure that the physical, virtual, and management IP addresses do not conflict with each other. This is because the physical and virtual IP addresses that you are supposed to enter are the start IP addresses �?ISM then automatically configures subsequent IP addresses based on the number of network ports.

How Can I Do If the Start Physical IP Address Fails to Be Connected?
If a PC fails to connect to the start physical IP address of the file engine's management network port, perform the following operations: ? Check whether management network cables are correctly connected. ? Ensure that other IP addresses of the file engine are on the same network segment with its start physical IP address. For example, the configured start physical IP address of a file engine is 192.168.1.1/255.255.0.0. The file engine's access network ports must have an IP address from the 192.168.X.X network segment. ? Run ping.

Actions to be taken if an account of a WLAN device is locked
For WLAN devices, if incorrect password is entered repeatedly during a certain period of time, the account will be locked. Generally, the account will be automatically unlocked after 5 minutes. Therefore, if an account is locked, try again 5 minutes later, or use another user account to log in to the device.

Can S series switches be configured not to take any action after a loop is detected
Huawei S series (except the S1700) and E series switches performs the configured default action after detecting a loop, that is, shutting down interfaces. The action can be changed but cannot be disabled. When the action is changed to trap, the switches only report traps and do not take any other action after detecting a loop. Command used to configure the action performed on an interface after LDT detects a loop: loop-detection mode { port-trap | port-blocking | port-nolearning | port-shutdown | port-quitvlan } Command used to configure the action performed on an interface after LBDT detects a loop: loopback-detect action { block | nolearn | shutdown | trap | quitvlan } Note: For S series switches, the port-quitvlan and quitvlan actions are supported in V200R002 and later versions.

Actions taken if ISM can detect storage devices but cannot detect file engines
This fault occurs if no deployment tools are used for deployment and the procedure of manual deployment is incomplete, or the file engine information on the storage devices was deleted. To rectify the fault, enter the engineer mode on the storage device and run the chgnasinfo command to register the management IP address of the file engine again.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top