How to configure rate limiting based on the IP address through the web platform on the AR

19

The procedure for configuring rate limiting based on the IP address through the web platform is as follows:
1. Choose QoS > Interface Rate Limit to access the Interface Rate Limit.
2. Click Create in Interface Rate Limit List.
3. On the Create Interface Rate Limit page, select IP, and select or enter parameters.
4. Click OK to save the parameter settings.

Other related questions:
How to configure interface-based rate limiting through the web platform on the AR
1. Choose QoS > Interface Rate Limit to access the Interface Rate Limit page. 2. Click Create in the Interface Rate Limit List toolbar. 3. On the Create Interface Rate Limit page, select or enter parameters based on requirements. 4. Click OK to save the parameter settings. To delete interface-based rate limiting, perform the following operations: 1. Choose QoS > Interface Rate Limit to access the Interface Rate Limit page. 2. In the Interface Rate Limit List toolbar, select the interface where the rate limtiing configuration needs to be deleted and click Delete. 3. In the displayed dialog box, click OK.

Configure rate limiting based on IP addresses
You can run the qos car command in the interface view to configure rate limiting based on IP addresses.

How to configure an AR to limit the rate of traffic based on MAC addresses
You can configure a traffic policy to limit the rate of traffic based on MAC addresses as follows: # traffic classifier mac1 operator and if-match source-mac 0015-c50d-0001 //Configure a matching rule based on the source MAC address 0015-c50d-0001 in the traffic classifier mac1. traffic classifier mac2 operator and if-match source-mac 0015-c50d-0002 //Configure a matching rule based on the source MAC address 0015-c50d-0002 in the traffic classifier mac2. traffic classifier mac3 operator and if-match source-mac 0015-c50d-0003 //Configure a matching rule based on the source MAC address 0015-c50d-0003 in the traffic classifier mac3. # traffic behavior d1 car cir 3000 cbs 564000 pbs 939000 mode color-blind green pass yellow pass red discard //Create the traffic behavior d1 and configure the rate limit to 3000 kbit/s. # traffic policy myqos //Configure the traffic policy myqos. classifier mac1 behavior d1 //Bind the traffic classifier mac1 to the traffic behavior d1. classifier mac2 behavior d1 //Bind the traffic classifier mac2 to the traffic behavior d1. classifier mac3 behavior d1 //Bind the traffic classifier mac3 to the traffic behavior d1. # interface GigabitEthernet 0/0/0 ip address 10.1.1.1 255.255.255.0 traffic-policy myqos inbound //Apply the traffic policy myqos to the inbound interface. #

Rate limiting based on IP addresses does not take effect on an AR
Verify that the interface to which rate limiting is applied is the router's interface connecting to intranet users or the interface does not have NAT configured. If the interface has NAT configured, ensure that it can match source and destination IP addresses correctly. For the intranet, inbound and outbound in the command indicate the source and destination IP addresses respectively.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top