How to Restore an Isolated File?

1

Restoring an isolated file must be performed on the antivirus console. The operation procedure is described in the help document of the antivirus software. InfoScanner currently supports Rising virtualization system security software v1.0.0.89 only, so you can refer to the quick user guide of Rising virtualization system security software v1.0.0.89.

Other related questions:
How to isolate STAs associated with the same SSID of an AP
Huawei APs support local Layer 2 isolation. After Layer 2 isolation is enabled, local STAs cannot communicate at Layer 2, and data can only be transmitted between uplink ports and VAP ports. To enable Layer 2 isolation, configure it on an AC.

Method used to isolate disks
Method used to isolate disks: 1. Locating procedure: The method is used to isolate disks impacting system services or proper running of the system. a. In most bilateral isolation cases, it is recommended that the pre-failure configuration be used. b. In the case of error code isolation and intermittent disconnection isolation, unilateral isolation and access, instead of slow disk isolation, are used. 2. Solution a. Bilateral isolation and access (simulating disk rejection and acceptance) Note: Disk rejection is mostly used for RAID recovery. In other cases, it is recommended that the pre-failure configuration be used for disk rejection. Isolation: Log in to the storage's MML mode and enter dev setdiskout enclosure ID slot ID to specify the enclosure number and slot number. Access: Log in to the storage's MML mode and enter dev setdiskin enclosure ID slot ID to specify the enclosure number and slot number. b. Unilateral isolation and access Note: It is mostly used for the error code isolation and intermittent disconnection isolation modes. Error code isolation and intermittent disconnection isolation mostly occur on unilateral isolation (that is, the disk has one link). In this case, you need to connect the disk to the system by using a link and continue to use the disk. If the disk has single link again later, replace the disk. Log in to the isolated controller. Unilateral isolation: Log in to the storage's MML mode and enter dev setdiskout enclosure ID slot ID 1. Unilateral access: Log in to the storage's MML mode and enter dev setdiskin enclosure ID slot ID 1. After unilateral isolation is performed, on the OSM page, the disk indicator becomes yellow. After unilateral access is performed, the disk indicator turns normal.

Configure port isolation on the S1728GWR-4P switch
Configure port isolation on an S1728GWR-4P switch as follows: 1. Choose Security > Port Isolation. 2. Set Interface to Port or Trunk. 3. Enable or disable port isolation on a specified interface or trunk. 4. Click Apply to complete the configuration.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top