How Can I Assign an IP Address to the Network Adapter of a Maintenance Terminal?

4

1.Choose Start > Run.

The Run dialog box is displayed.


2.Type Ncpa.cpl in Open, and then press Open.

The Network Connections window is displayed.


3.Double-click the icon of the network connection that you want to set, for example, Local Area Connection.

The Local Area Connection Status dialog box is displayed.


4.Click Properties.

The Local Area Connection Properties dialog box is displayed.


5.In the This connection uses the following items area, double-click Internet Protocol Version 4 (TCP/IPv4).

The Internet Protocol Version 4 (TCP/IPv4) Properties dialog box is displayed.


6.Select Use the following IP address, and set the following parameters:

IP address
Subnet mask

7.Click OK.

The Local Area Connection Properties dialog box is displayed.


8.Click OK.

The Local Area Connection Status dialog box is displayed.


9.Click Close.

Other related questions:
Whether the IP address of a maintenance network port can be changed
The IP address of a maintenance network port can be changed. You can use OceanStor DeviceManager or CLI to modify the IP address of a specified maintenance network port.

IP address planning of a storage device
Service network ports on the same controller must reside in different network segments and also must reside in different network segments from the management network port of the controller.

Can the TE40 be assigned a dynamic IP address?
Dynamic IP addresses can be configured for TE series endpoints, but must register with the GK or SIP server.

Can an IP address be directly assigned to a physical interface
An MEth management port is a Layer 3 interface. You can directly configure an IP address for the interface. To configure an IP address for a service interface, configure a VLANIF virtual interface, and assign an IP address to the VLANIF interface. Example: system-view [HUAWEI] vlan 10 [HUAWEI-vlan10] quit [HUAWEI] interface vlanif 10 [HUAWEI-Vlanif10] ip address 192.168.1.10 24 In V200R005C00 and later versions, run the undo portswitch command to change the working mode of Ethernet interfaces from Layer 2 mode to Layer 3 mode. Ethernet interfaces working at Layer 3 support IP address configuration.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top