RH2485 V2 hard disks

0

The hard disks of the RH2485 V2 are used for data storage and are hot-swappable. The server supports eight 2.5-inch SAS HDDs, SATA HDDs, or SSDs.

The maximum storage capacity of the RH2485 V2 varies with the disk type.
? SAS HDDs: 7.2 TB
? SATA HDDs: 8 TB
? SSDs: 4.8 TB

The RH2485 V2 supports RAID levels of 0, 1, 10, 1E, 5, 50, 6, and 60. It provides the 512 MB or 1 GB cache and supports battery protection and capacitor protection for the cache. In addition, the RH2485 V2 supports RAID state migration, RAID configuration memory, self-diagnosis, and web-based configuration.

The mainboard is configured with an SAS RAID controller card (with cache) for user data protection.

The RAID controller card does not occupy a standard PCIe slot, improving system scalability.

The RH2485 V2 provides two ports for connecting an embedded USB flash drive and an embedded USB flash memory card.

Other related questions:
Server price
Please consult your local Huawei sales representative.

Whether the USG6650 hard disk has a hard disk card
The USG6650 supports two types of hard disks, namely, SM-HDD-SAS300G-A and SM-HDD-SAS300G-B. Model A uses the tray of the device, and model B has its own tray.

Hard disk capacity of servers
For details about the hard disk types and capacities, see the server compatibility list.

Query hard disk SN of a server
The hard disk serial number (SN) starts from 2102. You can obtain SN information from the SN label on the hard disk case.

Hard disk capacity expansion for the USG6000 series
The USG6650/6660/6670/6680 supports dual hard disks. Do as follows to install a hard disk on the USG, which has been running for some time with a single hard disk: 1. Ensure that all configurations are saved. 2. Run the disk offline command in the system view. Wait for about 30 seconds until the system indicates that the hard disk stops working, remove the filler panel from the hard disk slot, and install a new hard disk unit. a. Remove the filler panel from the hard disk slot. HDD1 is used as an example. b. Hold the handlers of the tray and push the tray along the guide rails inside the hard disk slot till the tray panel aligns with the panel of the device. c. Press the tray handler inwardly to restore the tray. d. In the system view, run the reset raid primary-disk disk-id command to create a RAID group using disk-id as the primary disk for data synchronization. In this example, the command shall be reset raid primary-disk 0. Several hours later, run the display disk information command. If Filesystem Status is Mounted and DiskRaidMode is ACTIVE, both hard disks work properly. Note: After the RAID is created, the data in the active disk will be synchronized to the backup disk and the original data on the backup disk will be overwritten. Select the disk-id of the active disk before creating RAID.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top