RH2288H V3 NICs

2

Four types of NICs are supported, which provide the following network ports:
? Two GE electrical ports, supporting NC-SI, Wake on LAN (WOL), and Preboot Execution Environment (PXE)
? Four GE optical ports, supporting NC-SI, WOL, and PXE
? Two 10GE optical ports, supporting NC-SI and PXE
? Two 10GE electrical ports, supporting NC-SI, WOL, and PXE


The server also provides PCIe slots for installing various NICs. For details, see the Huawei Server Compatibility Checker at http://support.huawei.com/onlinetoolsweb/ftca/en.

Other related questions:
What is the function of the NIC in the RH2288 V3
The RH2288 V3 supports one GE NIC with two or four GE ports, or supports one 10GE NIC with two 10GE electrical or optical ports or with two GE electrical ports and two 10GE optical ports. Both NICs support the Network Controller Sideband Interface (NC-SI). The RH2288 V3 supports a 56GE NIC with two 56GE IB optical ports. The NIC does not support NC-SI.

What is the function of the NIC in the RH1288 V3
The RH1288 V3 supports one GE NIC with two or four GE ports, or supports one 10GE NIC with two 10GE electrical or optical ports or with two GE electrical ports and two 10GE optical ports. Both NICs support the Network Controller Sideband Interface (NC-SI). The RH1288 V3 supports a 56GE NIC with two 56GE IB optical ports. The NIC does not support NC-SI.

What modules could Tecal Nagios plug-in managed for RH2288H V3 and RH5885H V3?
In addition to PSU, fan module, and RAID controller alarms, RH2288H V3 and RH5885H V3 can report temperature, Watchdog, sub management system, hard disk, and memory alarms.

RH2288 V3 health indicator
RH1288 V3, RH2288 V3, RH2288H V3 health indicator status description: ? Steady green: The server is operating properly. ? Blinking red at 1 Hz: A major alarm is generated. ? Blinking red at 5 Hz: A critical alarm is generated.

Entering the RAID configuration interface
If the server is configured with an LSI 1078, 2208, or 3108 RAID card, press Ctrl+H during the server startup process. If the server is configured with an LSI 1064, 1068, 2308, or 3008 RAID card, press Ctrl+C during the server startup process. If the server is configured with SoftRAID, press Ctrl+M after the hard disk self-test during the server startup process.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top