Can load balancing be implemented when multiple interfaces of the AR router are mapped to internal servers

4

When multiple interfaces of the AR router map to internal servers, load balancing can be implemented. You can run the load-balance { dst-ip | dst-mac | src-ip | src-mac | src-dst-ip | src-dst-mac } command.

Other related questions:
Does an AR support load balancing when multiple ports are mapped to the intranet server
You can run the load-balance { dst-ip | dst-mac | src-ip | src-mac | src-dst-ip | src-dst-mac } command to implement load balancing when multiple ports are mapped to the intranet server on an AR.

Can the AR implement link aggregation or load balancing when multiple AR uplinks are used to access the Internet
If physical interfaces of multiple uplinks are of the same type (GE or Ethernet interfaces), these interfaces can constitute an Eth-Trunk. The bandwidth of the Eth-Trunk is the sum of bandwidths of multiple physical links. For example, the bandwidths of two Ethernet interface are 200 Mbit/s (100 Mbit/s + 100 Mbit/s). If two service interfaces are used, for example, bandwidths of two carriers are leased, among which one is 4 Mbit/s and the other is 2 Mbit/s, 6 Mbit/s bandwidth for Internet access cannot be implemented. If ECMP is configured on the two service interfaces, Internet access through one uplink may be faster than Internet access through the two service interfaces. This is because two carriers use different networks on which the delay and jitter are different. Mis-sequencing of TCP packets (most services use TCP) may occur. As a result, TCP packets are reassembled and retransmitted, or even TCP connections are torn down and reestablished. The Internet access speed is slow and web pages cannot be opened. Use the following methods to solve the problem: -Use specific routes to different services, do not use ECMP, or use only one uplink interface. -Use a traffic policy containing redirection to next hop addresses so that services are not load balanced.

Can the AR router implement one-to-one mapping of multiple port numbers?
AR router can configure NAT static and NAT port to achieve one to one mapping. For example: NAT server TCP global 1.1.1.2 21 inside 10.3.0.30 21 server.

Can the AR router implement one-to-one mapping between multiple port numbers
The AR router can be configured with static NAT or the NAT server to implement one-to-one mapping, for example, nat server protocol tcp global 1.1.1.2 21 inside 10.3.0.30 21.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top