RH1288A V2 hard disk

0

HDDs are hot-swappable and store data for the RH1288A V2. The RH1288A V2 supports the following hard disk configurations:
? RH1288A V2 (8 hard disks), supporting eight 2.5-inch SSDs or SAS/SATA HDDs
? RH1288A V2 (4 hard disks), supporting four 3.5-inch SAS/SATA disks.

Other related questions:
Differences among RH1288A V2, RH1288 V2, and RH1288 V3
The differences among the RH1288A V2, RH1288 V2, and RH1288 V3 are listed as follows. The servers' specifications are subject to the official website. ? The RH1288A V2 adopts the Huawei Hi1710 management chip (iBMC), and supports Intel? Xeon? E5-2600 v2 series processors, eight DIMM slots, and two LOM GE electrical ports. ? The RH1288 V2 adopts the management software iMana, and supports Intel? Xeon? E5-2600 and E5-2600 v2 series processors, 24 DIMM slots, and GE or 10GE LOM NIC modules. ? RH1288 V3 adopts the Huawei Hi1710 management chip (iBMC), and supports Intel? Xeon? E5-2600 v3 series processors, 16 DIMM slots, and GE or 10GE LOM NIC modules.

Whether the USG6650 hard disk has a hard disk card
The USG6650 supports two types of hard disks, namely, SM-HDD-SAS300G-A and SM-HDD-SAS300G-B. Model A uses the tray of the device, and model B has its own tray.

Hard disk capacity of servers
For details about the hard disk types and capacities, see the server compatibility list.

Query hard disk SN of a server
The hard disk serial number (SN) starts from 2102. You can obtain SN information from the SN label on the hard disk case.

Hard disk capacity expansion for the USG6000 series
The USG6650/6660/6670/6680 supports dual hard disks. Do as follows to install a hard disk on the USG, which has been running for some time with a single hard disk: 1. Ensure that all configurations are saved. 2. Run the disk offline command in the system view. Wait for about 30 seconds until the system indicates that the hard disk stops working, remove the filler panel from the hard disk slot, and install a new hard disk unit. a. Remove the filler panel from the hard disk slot. HDD1 is used as an example. b. Hold the handlers of the tray and push the tray along the guide rails inside the hard disk slot till the tray panel aligns with the panel of the device. c. Press the tray handler inwardly to restore the tray. d. In the system view, run the reset raid primary-disk disk-id command to create a RAID group using disk-id as the primary disk for data synchronization. In this example, the command shall be reset raid primary-disk 0. Several hours later, run the display disk information command. If Filesystem Status is Mounted and DiskRaidMode is ACTIVE, both hard disks work properly. Note: After the RAID is created, the data in the active disk will be synchronized to the backup disk and the original data on the backup disk will be overwritten. Select the disk-id of the active disk before creating RAID.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top