Which management module is the E9000 connected to for management?

If the E6000 is configured with two management modules and the two management modules work in active/standby mode, you need to connect to the active management module to implement management. You can determine the active/standby status of management modules by using the ACT indicators. If the ACT indicator of a management module is steady green, the management module is the active one. If the ACT indicator of a management module is blinking, the management module is the standby one.

The E6000 cannot access a switch module in this mode because it does not have the SOL function. You can configure a switch module IP address on the management module, and then connect to the switch module network port to access the switch module by using the client.

The E9000 server can connect to compute nodes and switch modules in the chassis by using the SOL function provided by the MM910, facilitating remote maintenance. For details, visit the following link: http://support.huawei.com/ehedex/pages/DOC1000053358YEF0907R/08/DOC1000053358YEF0907R/08/resources/en/out/e9000_grua_inst_ch220/SemiXML%28e9000_ch220_semi%29/osca/chassis_troubleshooting/it_osca_troubleshooting_500015.html

On the MM910 WebUI, you can choose Chassis Settings > Network Settings > MM to view and set network parameters such as the IP address, gateway, and DNS of the MM910. For details, visit the following link: http://support.huawei.com/ehedex/pages/DOC1000053358YEF0907R/08/DOC1000053358YEF0907R/08/resources/en/osca/smma_help_r2/it_osca_smma_900041.html