CX310 CLI login methods

3

You can log in to the CX310 CLI by using the following modes:
? SSH mode (remote)
? SOL mode (remote)
? SYS serial port mode (local, a BMC serial port is required for plane switchover)

For details, see Logging In to the CLI of Each Switching Plane in the user guide.
CX310 User Guide:
? C00 version:
http://support.huawei.com/enterprise/en/doc/DOC1000018094/?idPath=7919749%7C9856522%7C21782478%7C19955021%7C19961380
? C10 version:
http://support.huawei.com/enterprise/en/doc/DOC1000068626/?idPath=7919749%7C9856522%7C21782478%7C19955021%7C19961380

Other related questions:
CX310 ports
The CX310 provides the following external ports: ? One BMC serial port, which is used for logging in to the BMC CLI. ? One SYS serial port, which is used for local management, maintenance, and GE switching plane commissioning. ? Sixteen 10GE optical ports, which are used for exchanging data with external networks. The CX310 provides the following internal ports: ? Thirty-two 10GE ports, which are connected to half-width compute node slots 1 to 16. The subcards corresponding to the slots are numbered from 1 to 16. ? One 40GE port, which is used to interconnect the switch modules in slots 1E and 4E or in slots 2X and 3X. ? Two GE ports, which are connected to the two MM910s respectively for communicating with the internal ports eth0 and eth2 on the MM910s.

Number of concurrent server BMC connections
The WebUI of server iBMC or iMana supports a maximum of four concurrent logins. The CLI supports a maximum of five concurrent logins.

Default user name and password of the CX31x
The default user name and password of the BMC and converged switching plane of the CX31x are as follows: Default user name: root Default password: Huawei12#$ The default user name and password of the FCoE gateway (available only for the CX311) are as follows: Default user name: admin Default password: Huawei12#$

How can I disable the MCU web login function in CLI mode?
To disable the MCU web login function in CLI mode, perform the following operations: Log in to the MCU main control board in Telnet or SSH2 mode (the user name and password are admin and admin or admin and Change_Me). Access the system configuration interface. Then, run the following commands: sys [HUAWEI VP9630]telnet-config [HUAWEI VP9630-Telnet]enable- enable-http enable-logon enable-network-login enable-security-mode //Set enable-http to 0 to disable the web login function. [HUAWEI VP9630-Telnet]enable-network-login enable-network-login [HUAWEI VP9630-Telnet]enable-network-login - mode{0:only enable FE0, 1:only enable GE0, 2:only enable GE1 3:enable all interface, default:3} //For security purposes, you may need to disable some ports.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top