An AR used as a DHCP client cannot obtain an IP address

12

When the configuration is correct, you can shorten the IP address lease. If the IP address lease is long, after addresses in the address pool are allocated, the address that has been allocated to a client is no longer used and cannot be released. As a result, other DHCP clients cannot obtain the IP address.

Other related questions:
DHCP client cannot obtain a correct IP address
The request packets (DHCP discover) are broadcast by the DHCP clients. If multiple DHCP servers are located on the same subnet (for example, bogus DHCP server), the clients may obtain IP addresses from a bogus DHCP server. To address this problem, configure DHCP snooping. Then clients can receive DHCP packets from only the trusted DHCP server. Perform the following configuration: [Huawei] dhcp enable [Huawei] dhcp snooping enable [Huawei] interface gigabitethernet 1/0/1 //Enter the view of the interface connected to the DHCP client. [Huawei-GigabitEthernet1/0/1] dhcp snooping enable [Huawei-GigabitEthernet1/0/1] quit [Huawei] interface gigabitethernet 1/0/2 [Huawei-GigabitEthernet1/0/2] dhcp snooping trusted //Configure the interface of the DHCP server as the trusted interface. [Huawei-GigabitEthernet1/0/2] quit Note: - When you configure DHCP snooping on a Layer 2 access device, steps 1, 2, and 3 are mandatory and must be performed in the following sequence. - When you configure DHCP snooping on a DHCP relay agent, only steps 1 and 2 are required.

DHCP clients cannot obtain IP addresses. How do I solve this problem
Ensure that the DHCP configuration is correct, and reduce the IP address lease. If a long IP address lease is set, after all addresses in the address pool are allocated, addresses that are not required cannot be released immediately. As a result, other DHCP clients cannot obtain IP addresses.

DHCP clients fail to obtain IP addresses from the DHCP server on the AR
The causes that DHCP clients fail to obtain IP addresses from the DHCP server are as follows: - The configuration is incorrect. - There is no allocable IP address in the DHCP address pool. - STP is enabled on upper-level access devices of some diskless workstations. For details on troubleshooting and solutions, see AR150&AR160&AR200&AR510&AR1200&AR2200&AR3200 FAQ.
About the AR ClientExceptions occurs when the IP address is obtained. For details, see the Revelations of Troublesolving on the right page.

Clients cannot obtain IP addresses through DHCP after the DHCP relay agent is upgraded
This problem may occur on a fixed switch in the following scenario: - The switch was upgraded from V100R002/V100R003 to V100R005/V100R006. - The switch functions as a DHCP relay agent and is configured with the dhcp relay information enable command. - An authentication mechanism is enabled before the DHCP server allocates an IP address to a client. The authentication server authenticates the client based on the option 82 field. After the dhcp relay information enable command is configured on the switch, the interface name that the switch encapsulates in the DHCP option 82 field varies according to the system software version: - For V100R003 and earlier versions, a VLANIF interface name is encapsulated. - For V100R005 and later versions, a physical interface name is encapsulated. As different interface names may be encapsulated in the option 82 field before and after the upgrade, the authentication server may fail to authenticate the user based on the option 82 field. If this problem occurs, modify the user authentication configuration on the authentication server after the upgrade. To be specific, change the content of the option 82 field on the authentication server to the physical interface name, or change the user authentication policy by disabling DHCP option 82 field-based authentication.

The DHCP client cannot obtain DNS information on the AR
DPossible causes are as follows: 1. The route from the AR to the DHCP server is unreachable. 2. The DNS and DHCP configuration modes are different. When the DHCP server assigns an IP address and gateway address to a client, the DHCP server also sends the DNS server address to the client. Ensure that the DNS server address and DHCP server address are configured in the global address pool or on an interface so that the DHCP server can find the DNS server IP address and deliver it.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top