Stacking of E6000 NX112 switch modules

4

After the stack cable is connected to the NX112 switch modules, stack configuration will be automatically performed.

Other related questions:
Default user name and password of the NX112
The default user name and password of the NX112 management network port are as follows: Default user name: root Default password: Huawei12#$

How does the E6000 telnet to a switch module by using a management module?
The E6000 cannot access a switch module in this mode because it does not have the SOL function. You can configure a switch module IP address on the management module, and then connect to the switch module network port to access the switch module by using the client.

Whether switch modules used on the E6000 support NAT
The switch modules used on the E6000 do not support the NAT function.

E6000 network port mapping
The on-board NICs of an E6000 are connected to switching planes A1 and A2. The E6000 provides two mezzanine slots (MEZZ 1 and MEZZ 2) for port expansion. The card in MEZZ 1 communicates with B1 and B2 switch modules, and the card in MEZZ 2 communicates with C1 and C2 switch modules.

Which management module is the E6000 connected for management?
If the E6000 is configured with two management modules and the two management modules work in active/standby mode, you need to connect to the active management module to implement management. You can determine the active/standby status of management modules by using the ACT indicators. If the ACT indicator of a management module is steady green, the management module is the active one. If the ACT indicator of a management module is blinking, the management module is the standby one.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top