Impact of restart on E9000 switch module TR mode

3

If the TR mode is set for E9000 switch modules, the restart will not change the TR mode.

Other related questions:
E9000 switch module working mode
When connecting the CX311 or CX911 switch modules of E9000 servers with FC switches through FC ports, you must change the working mode of the switch modules. The CX311 FCoE gateway and CX911 FC switching plane provide two working modes: Full Fabric (default mode) and Transparent (TR). You must set the working mode based on the connected devices. For details about the specific configuration, query with the keyword "CX311 working mode" or "CX911 working mode".

E9000 switch module configuration assistant
Go to Link.

Compatibility between E9000 switch modules and subcards of blades
For details about the mapping between the E9000 switch modules and the mezzanine cards of the blades, see http://support.huawei.com/huaweiconnect/enterprise/thread-268293.html.

Whether switch modules used on the E9000 support NAT
The switch modules used on the E9000 do not support the NAT function.

What are the differences between AP restart modes and what are their application scenarios
You can restart an AP in the following ways: run the reset command on the AC, log in to the AP and restart it, hold down the RESET button on the AP, and power off and on the AP. The differences and application scenarios of these restart modes are as follows: - Run the reset command on the AC: Run the ap-reset { all | id ap-id | ap-type { type ap-type | type-id type-id } } command in the WLAN view to restart a specified AP or APs in batches. This command applies only to online APs. - Log in to the AP and restart it: Log in to the AP and run the reboot command in the user view to restart the AP. You can restart an AP using this method only after you log in to the AP using Telnet or through the console port. This method is used to restart APs that are not online on the AC. You can connect a PC to the wired interface of the AP and log in to the AP using Telnet. - Hold down the RESET button on the AP: Using this method, you can restart an AP without the need to get the AP online or log in to the AP. - Power off and on the AP: If the AP uses PoE power supply, run the undo poe enable and poe enable commands in the interface view of the power sourcing equipment (PSE) to restart the AP.

If you have more questions, you can seek help from following ways:
To iKnow To Live Chat
Scroll to top