Hello, guys!
Have a nice day!
This topic describes the solution to configure the number of retry attempts upon convening failure when we schedule a meeting on U19.
If the user to join the meeting is busy or does not answer the call upon the meeting start, the system does not call the user again by default. You can set software parameter 363 to enable the system to call a user again when the user is busy or does not answer the call. The number of retry attempts is controlled by the software parameter value.
For example, if you set the software parameter to 3 and a participant is busy or does not answer the call within 1 minute, the system calls the participant 1 minute later. For three successive failures, convening the user is considered to be failed. The system does not call the user again.
1. Log in to a U1900 series unified gateway using the CLI and access the Config mode.
2. Set the number of retry attempts, such as 3.
config softargu type 363 value 3
Thanks for reading!
That is all!
