To allow users to view CDRs on the BMU, configure the CDRServer on the BMU side.
The BMU can obtain CDRs from the directory where CDRs are stored on the CDRServer through an FTP or FTPS interface. The default directory is D:\Bill\CurFile.
- Log in to the BMU as the admin user.
- Choose .
The CDR Configuration page is displayed.
- Configure CDR information, as shown in Figure 1.Figure 1 CDR Settings
Set the following parameters:CDRServer IP Address: Indicates the CDRServer IP address.
- Port: Indicates the FTP or FTPS service port, which must be the same as the setting on the FTP/FTPS Server.
FTP User Name: Indicates the FTP user name for obtainin****Rs. The user name is configured during the FTP or FTPS Server installation.
FTP Password: FTP user name for CDRs. The user name is configured during the FTP or FTPS Server installation.
- FTP: It is recommended that you use the FTPS protocol. Using FTP to transfer files may bring some security risks because FTP is an insecure protocol.
- The interval for obtainin****Rs must meet the following requirements:
- In V200R002C00SPC206 or an earlier version, the recommended value does not exceed the link timeout value (default: 5 min) of the FTPServer. Cause: A reconnection mechanism does not exist between the BMU and FTPServer. When the FTP Server is disconnected, CDRs cannot be obtained.
- In V200R003C00 or a later version, a reconnection mechanism exists between the BMU and FTPServer, and the interval value is not restricted.
- Click Connect.
- Click OK.
