Hello, everyone!
Today, I will explain configure of voice service on the ONT side. It is assumed that the VoIP configuration on the OLT side is complete. There are six steps for this configuration. Let's get started!
1. Log in to the ONT
The first step is to log in to the ONT (see fig.1). There are several ways to connect to the ONT (remote or directly). For log in we use:
IP address: 192.168.X.X/24
username: telecomadmin
password: XXXXXXXX
Figure 1. Log in on the ONT HG8247H
2. WAN port configuration
When we log in on the ONT, the next step is WAN port configuration (WLAN>WLAN Basic Configuration). We must fill in the following parameters (Fig.2):
Enable WAN – enable WAN for VoIP service
WAN mode: Route WAN – choice of the WAN mode
Service type: VOIP – choice of VoIP service
VLAN ID: 802 – VoIP VLAN
IP address: X.X.1.33 – input the IP address
Subnet mask: X.X.0.0 – input the subnet mask
Default Gateway: X.X.0.1 – input the default gateway
And click Apply.
Figure 2. WAN port configuration
3. Test for connection
When we finished step 2, we can check connectivity. We use the next steps: System Tools – Maintenance, and then we put URL or IP address on the URL or IP and VoIP for WAN Name. And the end, we can start the test – click Start.
Figure 3. Connectivity test
4. Route configuration
The fourth step is route configuration (Route>Default Route Configuration). We have to enable the default route and choice VoIP for WAN. In this way, we enable the routing of VoIP traffic.
Figure 4. Route Configuration
5. VoIP basic profile parameters configuration
One of the main steps in this step. We have to configure voice interface, digitmap and digitmap matching mode. We use next steps: Voice>VoIP Basic Configuration>Basic Profile Parameters(SIP) (Fig. 5). Primary proxy address is IP address of the SIP server (softswich) – X.X.14.120, and its port number is 5060. There are rules for digitmap. With the SIP digitmap command, we set the dialing rule. We put VoIP for Signaling port and Media port.
Figure 5. Voip Basic profile parameters Configuration
6. VoIP user configuration
This is the last step in the configuration procedure on the ONT side, but this is a very important step. Now we have to put the user phone number, password and associated POTS port. We use next steps: Voice>VoIP Basic Configuration>Basic User Parameters(SIP). The next picture shows us this configuration.
Figure 6. VoIP user configuration
After this step, VoIP service is configured. Now we can see configuration results (Status>VoIP Information) and we can test the start loop (System Tools>VoIP Diagnose) and circuit test (System Tools>VoIP Diagnose).
Thank you!
