the endpoint will never go to sleep mode because the endpoint is "receiving" information from the camera all the time.
To solve the problem you need to input another setting like VGA IN and this will allow the device to go to sleep normally.
Configuration that prevent the TE30 to enter sleep mode
Created: May 23, 2018 07:20:26Latest reply: Jun 2, 2018 06:43:10
922
7
2
0
0
If you configure on the TE30 Device control > Device Control > Video Control at the Video Input Source as CAM IN, 
the endpoint will never go to sleep mode because the endpoint is "receiving" information from the camera all the time.
To solve the problem you need to input another setting like VGA IN and this will allow the device to go to sleep normally.
the endpoint will never go to sleep mode because the endpoint is "receiving" information from the camera all the time.
To solve the problem you need to input another setting like VGA IN and this will allow the device to go to sleep normally.
- x
- convention：
- Emotion(0)
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
