Category : Industrial
Capacity : 3.6 MWAC
Inverter : 100ktl Huawei Inverter
1. Download the Fusion Solar App
v First, open a browser in your phone and search solar.huawei.com/apac, then click the dashed-like icon in the upper right;
v Next, click Download FusionSolar APP;
v Click Open;
v Lastly, click Install
2. Commissioning Start up
v Commissioning must be done on the site, can also be done online but it is not recommended.
3. Inverter Commissioning Setup
v Click Connect;
v Scan the QR code of the USB-adapter. If QR scan failed, click the Manual connection (recommended).
v Then click the WLAN, WLAN default password is “Changeme”. Note: For M3 models, WLAN default password is in the right side of the inverter.
v Check the Current WLAN, if the SSID is right then click Connect (SmartLogger SSID name starts with “Logger” and then followed by _SNnumber, ex : Logger_10298231561).
Note: If SmartLogger’s SSID can’t be found, press the RST button (SmartLogger bottom part) for 3 seconds
v Once connected, in the Identity Authentication page, the username should be “Installer” for inverter, and “admin” for smartlogger, then the password is 00000a.
v After that, you will be directed to the Quick Settings page (during first time access), Change the Grid Code to IEC 61727. Change the voltage level accordingly usually, it is either 380/400/440V,
v For L1 Inverters, change the Grid Frequency to 60 Hz, then fill the rest of the section accordingly.
v Then, click next
v Click Confirm.
v If you want to change the login password, click Yes. If not, then click No.
v For multiple inverter, you can change the address of each inverters to avoid address conflict. Click Settings
v If you’re using SmartLogger for your project then exit the Quick Settings page. Click the arrow back (<) at the top left of the page. If you use a dongle or for an L1 inverters, you can add the Power Meter and any other devices.
4. Commisioning SmartLogger FusionSolar App – Adding Power Meter
v To add a Power Meter, go to Maintenance > then click Device Management
v Click the icon in the upper-right corner of the page
v Click Add Devices
v In the Device Type choose Meter, Port Number is based on where the Power Meter is connected in the SmartLogger's COM ports, Address is the default ID of the Power Meter
5. Power Meter Configuration
v Go to Settings;
v Then in the Intelligent Power Meter Type, select the corresponding Meter you used.
Note: If the Power Meter you used is not in the lists, you need to manually configure it using the SmartLogger’s WebUi (Enspire), you can follow the procedure below.
v To check the Power Meter data, go to Maintenance > Device Mgmt. > click Meter > then click Running Info
