Clear Data

Hi there!

As Laiheang said, you can run the erase flash data command to erase the configuration data in the flash memory of the control board. When the configured data is saved to the flash memory, you can run this command to restore the database to the initial state, namely, to erase the data configured by the user. After the command is executed successfully, the original configuration data in the flash memory of the control board is lost.

Usage Guidelines

Before erasing the data, run the backup data command to back up the database file to prevent the loss of important data.

During the process of command running, the system prompts you to confirm this operation.

During the process of command running, the system displays the progress, the suggestion when this command is executed successfully, and the cause in case of failure.

After this command is executed successfully, run the reboot command to reset the system to validate the data erasion operation.

After the data is erased, if the system is not reset within 2 days, the erasing operation is automatically canceled.

After the data is erased, you can run the load data command to reload the database file.

Example

To erase the configuration data of the active control board, do as follows:

To cancel configuration data erasion, do as follows:

Thank you!

Dear User,

You can use the erase flash data command to erase the configuration data from the flash memory of the control board. When the configured data is saved to the flash memory, you can run this command to restore the database to the initial state, namely, to erase the data configured by the user. After the data is erased successfully, all the original configuration data in the flash memory of the control board is lost.
Note:
After the preceding command is executed, all the configuration data in the system will be erased. Exercise caution.

Cheers,