- Choose .
- Enter cmd and press Enter.
- Run the ping device IP command, for example, ping 192.168.0.120.
- If the device can be pinged, go to Checking Whether the Browser Settings Are Correct.
- If the device cannot be pinged, go to the next step.
- Set network parameters.
- Open the current network connection attributes.
- Double-click Internet Protocol Version 4(TCP/IPv4). In the window that is displayed, click Advanced. The Advanced TCP/IP Settings window is displayed.
- Add the network segment where the device resides, as shown in Figure 1.Figure 1 Adding the network segment where the device resides
- Set network parameters.
- Open the current network connection attributes.
- Double-click Internet Protocol Version 4(TCP/IPv4). In the window that is displayed, click Advanced. The Advanced TCP/IP Settings window is displayed.
- Add the network segment where the device resides, as shown in Figure 1.Figure 1 Adding the network
- Add the network segment where the device resides, as shown in Figure 1
- Click .
- Disable all the firewalls.
- Check whether the fault is rectified.
- If yes, no further action is required.
- If no, go to the next step.
Revelations | Previous | Next
- Add the network segment where the device resides, as shown in Figure 1
- Set network parameters.
Checking Whether the Network Connection Is Normal
Created: Jan 9, 2019 08:54:55
240
0
0
0
0
- x
- convention：
- Emotion(0)
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
