Check IP Address Occupation Time

Hello everyone,

The display interface dialer 0 command on the USG6300 does not display the connection time of the IP address after PPPoE dial-up. Only the current system time is displayed. In earlier versions, the IP address connection time (occupation time) is obtained. Which command can display the duration of the dynamic IP address? Thank you!

<USG6300>dis interface Dialer 0

2020-03-01 07:21.579 +08:00

Dialer0 current state : UP

Line protocol current state : UP (spoofing)

Description:Huawei, USG6308 Series, Dialer0 Interface

Route Port,The Maximum Transmit Unit is 1492, Hold timer is 10(sec)

Internet Address is negotiated, 27.151.73.22/32 Link layer protocol is PPP

LCP stopped

Physical is Dialer

Current system time: 2020-03-01 07:21+08:00

    Last 300 seconds input rate 32 bits/sec, 0 packets/sec

    Last 300 seconds output rate 32 bits/sec, 0 packets/sec

    Realtime 0 seconds input rate 0 bits/sec, 0 packets/sec

    Realtime 0 seconds output rate 0 bits/sec, 0 packets/sec

    Input: 629194 bytes

    Output:628886 bytes

    Input bandwidth utilization  : 0.05%

    Output bandwidth utilization : 0.05%Bound to Dialer0:0

Dialer0:0 current state : UP

Line protocol current state : UP

 Link layer protocol is PPP

LCP opened, IPCP opened