Hello,

Configuring a Stack (CE12800, CE12800E, and CE16800)

Applicable Products and Versions

V100R001C00 and later versions

CE16800, CE12800 and CE12800E series switches (excluding the CE12800E configured with FD-X series cards)

For details about the mapping between software versions and switch models, see the Hardware Query Tool.

Networking Requirements

An enterprise builds a data center. The data center network must provide high reliability on the core layer and have a simple structure to facilitate configuration and management.

To meet requirements of the enterprise, core switches SwitchA and SwitchB set up a stack. Figure 2-16 shows the network topology.

Figure 2-16 Stack networking

Configuration Roadmap

The configuration roadmap is as follows:

1. Make a stack plan.

2. Connect SwitchA and SwitchB using stack cables based on the stack plan.

3. Configure stack software on SwitchA and SwitchB, including the stack member ID, stack priority, stack domain ID, stack connection mode, and stack port.

4. Save the configurations of SwitchA and SwitchB and enable the stacking function on the two switches.

5. Check whether a stack has been set up successfully.

6. 
   

Please find below the detail and the procedure link hope it can help you

https://support.huawei.com/enterprise/en/doc/EDOC1000039339/cdb88956/configuring-a-stack-ce12800-ce12800e-and-ce16800

Thanks

Dear @MAWK

Both core switches (Switch-1 and Switch-2) to be set up a stack

• Make a stack plan.

• Connect Switch-1 and Switch-2 using stack cables based on the stack plan.

• Configure stack software on Switch-1 and Switch-2, including the stack member ID, stack priority, stack domain ID, stack connection mode, and stack port.

• Save the configurations of Switch-1 and Switch-2 and enable the stacking function on the two switches.

• Check whether a stack has been set up successfully.