Can Rate Limiting Be Configured for an Eth-Trunk on a Modular Switch and How Can

Created: Feb 13, 2016 16:58:13Latest reply: Feb 13, 2016 18:23:27 1043 1 0 0

display all floors ^#1

Can Rate Limiting Be Configured for an Eth-Trunk on a Modular Switch and How Can the Configuration Take Effect?

x
convention：

Helpful (0) Favorite(0) Report

Osaideo Created Feb 13, 2016 18:23:27

The modular switches support rate limiting for inbound traffic on an Eth-Trunk. This function can be configured using the qos car command. After this command is executed:
If the member interfaces of the Eth-Trunk are located on different LPUs, the configured rate limit applies to each interface individually.
If the member interfaces of the Eth-Trunk are located on the same LPU, the member interfaces share the bandwidth specified by the rate limit. The bandwidth is distributed on the member interfaces randomly.

x
convention：

Comment

Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:

Politically sensitive content
Content concerning pornography, gambling, and drug abuse
Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy

Do not share your account and password with others. All operations performed using your account will be regarded as your own actions and all consequences arising therefrom will be borne by you. For details, see " Privacy."

Enterprise

Consumer

Corporate

Carriers

Can Rate Limiting Be Configured for an Eth-Trunk on a Modular Switch and How Can

Third Party’s Trade Secret