The S chassis switch support rate limit for incoming traffic on an Eth-Trunk. The rate limit is configured by using the qos car command. After rate limit is configured:
If the member interfaces of the Eth-Trunk are on different boards, the rate limit applies to each interface individually.
If the member interfaces of the Eth-Trunk are on the same board, the member interfaces share the bandwidth specified by the rate limit. The bandwidth is distributed on the member interfaces randomly.
Can Rate Limit Be Configured on an Eth-Trunk?
Created: Dec 29, 2015 09:54:56Latest reply: Apr 24, 2020 21:01:59
1622
3
0
0
0
- x
- convention：
- Emotion(0)
Comment
Notice: To protect the legitimate rights and interests of you, the community, and third parties, do not release content that may bring legal risks to all parties, including but are not limited to the following:
- Politically sensitive content
- Content concerning pornography, gambling, and drug abuse
- Content that may disclose or infringe upon others ' commercial secrets, intellectual properties, including trade marks, copyrights, and patents, and personal privacy
